Installation Manual
Manuals
Brands
Bosch Security Systems Manuals
Electronics
Allplex track
1
2
3
4
5
6
7
8
9
10
Table Of Contents
Title Page
Table of Contents
Copyright, Safety and Warranty
Copyright information
Important safety notes
Safety precautions
FCC information
System Overview
Mounting the Device
Indoor installation
Spacing
Mounting height
Multi-floor installations
Outdoor installation
Spacing
Mounting height
Overhangs/eaves
Pre-wired installations
Drilling templates
Drilling template for outdoor enclosure bottom entry
Drilling template for outdoor enclosure rear entry
Layout and Wiring of the Device
Layout of the coordinator/receiver
Power supply connector
Power over Ethernet (PoE) connector
RS-485 communication connector
RS-485 jumpers
Input connectors
Output connectors
LED indicators
Tamper switch
Reset button
Setting the Switches and Jumpers
Setting the loop address
Setting the radio frequency (RF)
Selecting the hard/soft reset mode
Setting the baud rate
Enable/disable the buzzer
Enable/disable the spacing mode
Enable/disable the transmit mode
Setting the jumpers for RS-485 communication loop
Troubleshooting the Device
Checking the power supply
Checking Power over Ethernet (PoE)
Checking Ethernet network issues
Checking the RS-485 communication
Checking the radio frequency (RF)
Resetting the coordinator/receiver
Upgrading coordinator/receiver firmware
Appendices
Differences between hard and soft reset mode on the coordinator/receiver
Back Page
7
Appendices
28
7.1
Differences between hard and soft reset mode on the coordinator/receiver
28
4
en | Table of Contents
ALLPLEX track Coordinator & Receiver
2014.03 | V1.0.0 | F.01U.277.701
Installation Guide
Robert Bosch (SEA) Pte Ltd
1
...
2
3
4
5
6
...
...
30
