Installation Manual

Table of contents
1
Copyright, Safety and Warranty 5
1.1 Copyright information 5
1.2 Important safety notes 6
1.3 Safety precautions 7
1.4 FCC information 7
2
System Overview 8
3
Mounting the Device 9
3.1 Indoor installation 9
3.1.1 Spacing 9
3.1.2 Mounting height 9
3.1.3 Multi-floor installations 9
3.2 Outdoor installation 10
3.2.1 Spacing 10
3.2.2 Mounting height 10
3.2.3 Overhangs/eaves 10
3.3 Pre-wired installations 10
3.4 Drilling templates 11
3.4.1 Drilling template for outdoor enclosure bottom entry 12
3.4.2 Drilling template for outdoor enclosure rear entry 13
4
Layout and Wiring of the Device 14
4.1 Layout of the coordinator/receiver 15
4.2 Power supply connector 16
4.3 Power over Ethernet (PoE) connector 16
4.4 RS-485 communication connector 16
4.5 RS-485 jumpers 17
4.6 Input connectors 17
4.7 Output connectors 17
4.8 LED indicators 17
4.9 Tamper switch 18
4.10 Reset button 18
5
Setting the Switches and Jumpers 19
5.1 Setting the loop address 20
5.2 Setting the radio frequency (RF) 20
5.3 Selecting the hard/soft reset mode 21
5.4 Setting the baud rate 21
5.5 Enable/disable the buzzer 22
5.6 Enable/disable the spacing mode 22
5.7 Enable/disable the transmit mode 23
5.8 Setting the jumpers for RS-485 communication loop 24
6
Troubleshooting the Device 26
6.1 Checking the power supply 26
6.2 Checking Power over Ethernet (PoE) 26
6.3 Checking Ethernet network issues 26
6.4 Checking the RS-485 communication 26
6.5 Checking the radio frequency (RF) 27
6.6 Resetting the coordinator/receiver 27
6.7 Upgrading coordinator/receiver firmware 27
ALLPLEX track Coordinator & Receiver Table of Contents | en 3
Robert Bosch (SEA) Pte Ltd Installation Guide 2014.03 | V1.0.0 | F.01U.277.701