User Manual

20
To use standard WEP security, select the Wireless Security screen shown below and select
WEP enabled. Choose from either 64 or 128 bit WEP Key Length, then enter the pass phrase.
It is recommended to use a pass phrase that consists of 10 or more characters. Make sure that
your clients use the same WEP pass phrase or hex keys. Select the WEP key to use for
transmitting data from the AP to the clients. For increased security, select Invisible from the
Visibility Status and change the keys periodically. If Invisible is selected, all clients will have
to manually enter the correct SSID in their configuration. When WEP is enabled, you should
also enable Deny Unencrypted Data and select either Open or Shared or Both Shared Key
Authentication. Make any changes you require, then click Save.