Manualshelf

User Manual

ManualsBrandsBosch Security Systems ManualsElectronicsHigh Power Wireless 802.11b Access Point
11121314151617181920
17
Configuration
To enter the Access Point Name, IP Address Mode, Default IP Address, Default Subnet
Mask and Default gateway, select the IP Network screen as shown below.
Each AP on your network should have a unique Access Point Name. This name is used when
upgrading firmware with the Telex Locator Tool.
We recommend using static IP addresses for all AP’s. However, if your network uses DHCP to
assign IP addresses automatically to the AP, you will not need the IP address, Subnet Mask or
Default Gateway. Select the DHCP option from the 2480AA AP IP Address Mode on the IP
Network screen to allow the AP to obtain an IP address automatically.
Make any changes you require, then click Save.