User Manual

15
Step 1: Change your computer network settings
a. Enable TCP/IP networking on your PC if you have not already done so, then right-click (use
the right mouse button) on the Network (My Network Places) icon on your computer’s
desktop and select Properties from the pop-up menu.
b. Right-click on Local Area Connections and select Properties from the pop-up menu.
c. Click on the installed TCP/IP protocol, then click Properties.
d. Enter the following settings: IP Address: 192.168.1.100
Subnet Mask: 255.255.255.0
Default Gateway: 192.168.1.1
e. Click OK to accept the settings.
f. The NIC must be set to 10 Mbps and “Proxy Server” must be unchecked under LAN settings.
You may add the IP address of this AP into the exceptions instead of disabling the proxy.
Restart your computer if prompted.
Step 2: Change the 2480AA AP settings
Open your web browser. (Internet Explorer 5.5 and 6.0 or Netscape 7.0 have been tested to work
properly. Other browsers may work but have not been verified.)
Open the following URL: 192.168.1.90 (select “try again” if the computer detects that you are
offline.)
The following window should appear:
The first time that you use this, just press OK. The User Name and Password will be set later.