User Manual

10
WARNING: Make sure that the antenna is pointed away from any humans or animals while
power is applied! A safe distance is approximately 7 inches or more.
The PoE injector box may be placed on the floor or mounted anywhere near the computer, hub,
switch or router.
The 2480AA AP LED’s (v 1.0.2 firmware)
There are 4 LED’s visible from the inside of the 2480AA AP. These can be seen when the door
is opened. When powered-up, the first green LED on the right side will be lit ONLY if the PoE
box is connected to an active Ethernet port. If it does not light, then check that all cables are
plugged into the PoE box and the power strip is turned on (if used). If power is supplied and the
cable is plugged into an active Ethernet card, hub, switch or router and the first green LED is not
lit, then move the switch on the PCB inside the CPE to the other position. If this LED is still not
lit, then check the wiring of the RJ45 plugs on the CAT-5 cable. Also check to make sure that
the computer, hub, switch or router is turned on. This green LED will fast blink when passing
Ethernet traffic. The second green LED will light steady when power is supplied to the unit.
Connect
to
2480 AP
Connect to hub,
switch, router or
computer
Connect
DC power
cable here