User Manual
Table Of Contents
Bosch Rexroth AG
RE 95 350/03.06
VAC Valve Control System
11/12
VACC connection diagram
!
!
6
!
6
6
*/)
!
"
!
"
!
"
#!.(
#!.,
4X$
232X$
#
$
"
%
!
'
&
(
#!.(
#!.,
!
"
6
6
Electronic supply
Supply of the power
outputs
Switched inputs
Sensor supply
voltage
Sensor supply
voltage
Voltage inputsCurrent inputsSwitched inputs
Switched inputs
Safety switch 2
Power input
Limit switch 1A
Limit switch 1B
Direction switch 4A
Direction switch 4B
Joystick 1
Compression factor 1
Joystick 2
Compression factor 2
Joystick 3
Compression factor 3
Joystick 4
Compression factor 4
Limit switch 2A
Limit switch 2B
Limit switch 3A
Limit switch 3B
Safety switch 1
Switched input
Direction switch 1A
Direction switch 1B
Direction switch 2A
Direction switch 2B
Direction switch 3A
Direction switch 3B
Proportional outputs
Valve 1
Valve 2
Valve 3
Valve 4
Error lamp
Switched output 1
Switched output 2
Switched output 3
Switched output 4
Switched output 5
Switched output 6
CAN bus
4
)
CAN bus
4
)
Ground connection
for housing
Switched outputs
1)
Short, low-resistance connection from a housing screw to the unit- or vehicle ground
2)
Separate ground connection from solenoid return line to the battery (chassis also possible)
3
) Separate fuses recommended for switches, sensors and electronics
4
) CAN bus: 120 Ω terminator recommended (see installation instructions RDE 90 300-01)
5
) Constant voltage source
6
) Observe maximum current consumption where proportional solenoids and switched outputs are controlled simultaneously
Figure 6: Inputs and outputs on the controller for the valve control system (VACC)