User Manual

14/20 Bosch Rexroth AG
RC RE 95203/11.07
Dimensions
267 ± 3
214.5
11.5
196
210 ±1
(195 ± 0.5)
45 ± 2
94.7
37 ± 2
(303.4 ± 5)
1)
160.3 ± 3
9 ± 0.5
18.7 ± 1.5
38.8 ± 1.5
1.45
41.8
Ø 0.6
6 x Ø 7
333.9 ± 5
214.3 ± 3
2)
Side view (long side)
Plan view
Illustration not to scale
Dimensions in mm
Underside view
Side view
(plug side with plug disconnected)
Fixing:
– The BODAS controller must be fixed at
6 points.
– Tightening torque MA = 8 ± 2 Nm for fixing
the BODAS controller with M6 screws.
– Tightening torque applies for mounting
without washer. The equivalent tightening
torque must be calculated when using
washers.
– Rexroth approval is required if mounting is
different from above.
– Installation point: evenness of mounting
surface 0.5
– The wiring harness should be fixated me
-
chanically in the area in which the control-
ler is installed (spacing < 150 mm).
The wiring harness should be fixated such
that a phase excitation with the control-
ler occurs (e.g. at the controller mounting
point).
If the mounting surface is not sufficiently
even, place flexible compensating elements
(e.g. rubber washers) between the fixing
points of the BODAS controller and the
mounting surface.
1
) Space required for mating connector
2
) Space required for plugging and unplug-
ging the mating connector
Contact surface