User Manual
Table Of Contents
10/16 Bosch Rexroth AG
RC RE 95201/11.07
Dimensions RC2-2/21
NBY
NBY
NJO
NBY
NBY
a b
c d
Fixing:
– The BODAS controller must be fixed at 4 points
(a, b, c and d).
– Tightening torque MA = 8 ± 2 Nm for fixing the
BODAS controller with M6 screws.
– Tightening torque applies for mounting without washer. The
equivalent tightening torque must be calculated when using
washers.
– Rexroth’s approval is required if mounting is different from
above.
– Installation point: evenness of mounting surface
0.5
– The wiring harness should be fixated mechanically in the
area in which the controller is installed (spacing < 150 mm).
The wiring harness should be fixated such that a phase
excitation with the controller occurs (e.g. at the controller
mounting point).
If the mounting surface is not sufficiently even, place flexible
compensating elements (e.g. rubber washers) between the fix-
ing points of the BODAS controller and the mounting surface.
1
) Space required for mating connector
2
) Space required for plugging and unplugging the mating
connector