User Manual

6/6 Bosch Rexroth AG Mobile Hydraulics
CEMA CAN Expansion Module RE 95 340/11.04
Bosch Rexroth AG
Mobile Hydraulics
Product Segment Mobile Electronics
Elchingen plant
Glockeraustraße 2
89275 Elchingen, Germany
Telephone [phone]
Fax [phone]
[e-mail]
www.boschrexroth.com/mobile-elektronics
© This document, as well as the data, specifications and other informations set
forth in it, are the exclusive property of Bosch Rexroth AG. Without their consent
it may not be reproduced or given to third parties.
The data specified above only serve to describe the product. No statements
concerning a certain condition or suitability for a certain application can be
derived from our information. The given information does not release the user
from the obligation of own judgement and verification. It must be remembered
that our products are subject to a natural process of wear and aging.
Subject to change.
Safety Instructions
• The suggested circuits do not imply any technical liability for
the system on the part of Rexroth.
• The safety instructions contained in RE 90301-01 must be
observed.
• Leads for speed sensors must be shielded. The shield
must be connected to the electronics on one side or to the
machine or vehicle ground via a low-resistance connection.
• Cables to the electronics must not be routed close to other
power-conducting cables in the machine or vehicle.
• Sufficient distance from radio systems must be maintained.
• All connectors must be unplugged from the electronics
during electrical welding operations.
• The electronics may only be tested with the proportional
solenoids connected.
• The proportional solenoids may not be connected to spark
suppression diodes.
Switching solenoids at the outputs of the RC electronics
need not be connected to spark suppression diodes.
Other inductive loads that are in the system but not
connected to the RC must be connected to spark
suppression diodes.
• In order to preserve the warranty, any installation or
replacement of the RC software (Flash EPROM) must be
performed by Rexroth personnel.
• Follow the RE 95 340-B operating instructions.