User Manual

4/4 Bosch Rexroth AG
WS1 RE 95140/07.07
© This document, as well as the data, specifications and other information set
forth in it, are the exclusive property of Bosch Rexroth AG. It may not be repro-
duced or given to third parties without its consent.
The data specified above only serve to describe the product. No statements
concerning a certain condition or suitability for a certain application can be de-
rived from our information. The information given does not release the user from
the obligation of own judgment and verification. It must be remembered that our
products are subject to a natural process of wear and aging.
Subject to change.
Bosch Rexroth AG
Hydraulics
Product Segment Mobile Electronics
Elchingen Plant
Glockeraustrasse 4
89275 Elchingen, Germany
Phone [phone]
Fax [phone]
[e-mail]
www.boschrexroth.com/mobile-electronics
Dimensions
Safety Notes
– The suggested circuits do not imply any technical liability for the system on the part of Rexroth.
– System developments and commissioning of electronic systems for controlling hydraulic drives must only be performed by
trained and experienced specialists who are suitably familiarized with working with the used components as well as the entire
system.
– No defective or incorrectly functioning components may be used. If the components should fail or demonstrate faulty operation,
repairs must be performed immediately.
– During commissioning, make certain that no one is present in the immediate working or movement range of the machine or can
be placed at risk by the machine.
– All connectors must be unplugged from the electronics during electrical welding and paint operations.
– Cables to the electronics must not be routed close to other power-conducting cables in the machine or vehicle.
– A sufficiently large distance to radio systems must be maintained.
– Cables/wires must be sealed individually to prevent water from entering the device.
M5x0,8 (DIN 13); 9 deep
max. tightening torque < 6 Nm