User manual

After short delay all devices in the network flash green 5 min (no
audible signal). If not, the connecting procedure failed or the
distance between the connected devices is too large (the
connected devices cannot reach each other). To extend the
operating range switch the repeater function on.
To stop the flashing earlier you press and hold the button for
about 10 s.
Notice!
The radio signal transmission can be obstructed due to
buildings or vegetation, walls, ceilings, radio frequency
interference. Significant inhibition of the wireless
signal results from the vicinity of solid steel beams,
large metal surfaces, or similar. The device does not
automatically indicate a reduced operating range or
loss of network connection.
Repeater function
If the network test has shown that not all devices can be
reached, then select the last reachable device and switch its
repeater function on to extend its operating range. One device in
the network can be configured as a repeater to cover long
distances. (1) See also www.boschsecurity.com/ferion/.
1. If the device is in normal mode (no optical signal) press and
hold the button for about 4 s until LED flashes orange
(connecting).
Wireless Smoke Alarm Graphics | en 11
Bosch Sicherheitssysteme GmbH 08.15 | 2.1 | F.01U.309.850