User manual

Attentively read the following instructions before programming.
Connecting devices
If the device which you want to connect was not in use before
proceed with step 1. If the device which you want to connect was
already in use, disassemble head and base. Then press and hold
the button for about 4 s to clear for installation. If it was already
element of a network, then reset it first, see Disconnecting a
device (Reset), page 12.
1. Both devices must be in operation (head and base
assembled) and in normal mode (no optical signal).
2. For both devices, press and hold the button for about 4 s
until both devices flash orange (connecting). -> After a short
delay the devices light up green (connecting successful) or
red (connecting failed).
To connect a further device, repeat the procedure for one device
of the existing network and the unprogrammed device. (Up to 40
devices can be interconnected.)
Once you have connected all devices and the devices are in
normal mode again (no optical signal), test the network.
Testing the network
In addition to the Functional check, page 12 (7), for each device,
test the network:
1. Select the device that has to cover the longest distance to
connected devices. To send a radio test signal, press and
hold the button for about 4 s until the LED flashes orange
(connecting).
2. Press and release the button (< 2 s).
10
en | Graphics Wireless Smoke Alarm
08.15 | 2.1 | F.01U.309.850 Bosch Sicherheitssysteme GmbH