Datasheet

English | 15
Fitting the application tool (seefigureC)
Pull the locking sleeve(3) forwards, guide the application tool into the tool
holder(2) as far as it will go, then release the locking sleeve(3) to lock the
application tool in place.
Operation
Starting Operation
IXO (3 603 JA8 0.., 3 603 JC7 0.., 3 603 JC7 1..) (seefigures D1 and
D2)
Clockwise: To drill and to drive in screws, slide the rotational direction
switch(5) all the way to the front.
Anti-clockwise rotation: To loosen or unscrew screws, slide the rotational
direction switch (5) backwards.
IXO (3 603 J81 0.., 3 603 J59 1.., 3 603 J59 3..) (seefigureD3)
Right rotation: To drill and to drive in screws, press the rotational direction
switch (5) through to the left stop.
Left rotation: To loosen and unscrew screws, press the rotational direction
switch (5) through to the right stop.
Switching on/off
To start the power tool, press and hold the on/off switch (6).
To switch off the power tool, release the on/off switch (6).
Working Advice
u Only apply the power tool to the screw when the tool is switched off.
Rotating application tools can slip off.
Maintenance and Service
Maintenance and Cleaning
u Keep the drilling adapter clean to ensure good, safe operation.
u Remove the drilling adapter from the screwdriver to clean it. There is
risk of injury from unintentionally pressing the on/off switch.
Bosch Power Tools 1 609 92A 5M1 | (14.09.2020)