Installation Instructions

Table Of Contents

English 3

Custom Drawer Front Dimensions

(Optional)

Build custom drawer front to the dimensions specified in Table 3 on page 3 and-

Table 4 on page 3 below. All four edges must be finished. If using wood, the back

must be sealed to prevent moisture damage.

Figure 3: Custom Drawer Front Dimensions

Power Requirements and

Grounding

Circuit Specifications: 120 V, 15 A, 60 Hz. The outlet must be properly grounded

in accordance with all applicable codes.

Installation Procedure

1) Prepare Cabinet Cutout Prepare cabinet cutout and install electrical connection according to the dimen-

sions in Figure 2 on page 2 and Table 2 on page 2.

2) Install Support Brackets When the opening does not have a bottom, or the bottom is not strong enough to

support the drawer, install the two support brackets included. Attach brackets 8”

(203.2 mm) from the front wall of the cabinet. Make sure that the brackets are

level before installing screws through screw holes into cabinet sidewalls (two

screws on each side). Note: Cabinet sidewalls must be strong enough to support

45 pounds (20.5 kg) each. See “Cabinet Cutout Dimensions” on page 2 for further

details.

C 22 1/4” (565.2 mm) 22 1/4” (565.2 mm)

D 7/16” (11.1 mm) 1 3/4” (44.5 mm)

Table 2: Cabinet Cutout Dimensions

Dimension Model

27” (685 mm) 30” (762 mm)

Table 3 Custom Drawer Front Dimensions

Dimension

Models

27” (685 mm) 30” (762 mm)

A 26 5/8” (676.3 mm) 29 1/4” (743 mm)

B 11 1/4’ (285.8 mm) 11 1/4” (285.8 mm)

C 1 1/4” (31.6 mm) 1 1/4” (31.6 mm)

D 1 1/4” (31.6 mm) 2 9/16” (65.1 mm)

E 2 3/4” (69.9 mm) 2 13/16” (71.5 mm)

F 2 1/4” (57.2 mm) 2 1/4” (57.2 mm)

G 21 1/16” (535 mm) 23 5/8” (600.1 mm)

Pilot Holes

1/2" (12.7 mm)

Diameter Hole