Installation Manual

LECTUS select General | en 13
Bosch Security Systems B.V.
Installation manual
2021-01 | 01 | F.01U.389.837
2.6 Transponder data
The support of the transponder media listed below depends on the respective variant or
reading technology (hardware platform) and the respective reader firmware.
The following non-exhaustive list includes transponder media that is supported by the reader.
RF standard Supported LEGIC
transponders
Other supported
transponders **)
LEGIC RF standard MIM22, MIM256, MIM1024,
CTC4096-MP410
ISO 14443 A
(also NFC Forum Type 2/4A
Tag *)
ATC512-MP, ATC2048-MP,
ATC4096-MP, CTC4096-
MP410, AFS4096-JP
according to ISO 14443 part
3/4:
e.g. Infineon SLE, SmartMX
Integrated support of MIFARE
Ultralight, MIFARE Classic,
MIFARE Plus and MIFARE
DESFire NFC peer-to-peer
target
ISO 14443 B ***)
(also NFC Forum Type 4B Tag
*)
according to ISO 14443 part
4:
e.g. B. InfineonSLE
ISO 15693
(also ISO 18000-3 mode 1)
ATC128-MV, ATC256-MV,
ATC1024-MV
Selected types, e.g. B. EM
4035, Infineon SRF55VxxP,
Tag-It HFI
INSIDE Secure (UID only) according to INSIDE Secure
*) Passive mode, initiator
**) Access with transparent mode (assigned commands for MIFARE transponders)
***) If transponders according to ISO 14443 B (2001) are used, only one transponder is
allowed in the RF field. This restriction does not apply to transponders according to ISO
14443 B (2008).
****) The SONY FeliCa protocol is supported in accordance with ISO 18092 (6 byte
introduction). Older FeliCa cards with a shorter introduction are not supported.
i
Notice!
Recommendation when using smart card chips for LEGIC "card in card" solutions:
A suitability and functional test of the corresponding medium should be carried out before
use or if it is planned to be used.