Instructions / Assembly

- 6 -
End Guards
1
BACK GUARD
1
Parts List "F"
Item Description Req'd.
1 End Guard 1 pair
2 .312 (5/16) - 18 x .500 (1/2) Phillips T.H.M.S. 4
3 .312 (5/16) - 18 Keps Nut 4
Parts List "G"
Item Description Req'd.
1 Back Guard 1
2 .312 (5/16) - 18 x .500 (1/2) Phillips T.H.M.S. 7
3 .312 (5/16) - 18 Keps Nut 7
Position end guard (Item 1) so that the two holes align with the holes in
the side of the attachment channel. Fasten end guard to channel with
(2) screws and nuts (Items 2 & 3) as provided. Repeat procedure at the
other end.
This completes the End Guard assembly.
Position back guard (item 1) so that the ovals in the lower edge of the back
guard are in line with the holes in the back edge of the bench top. (Flanges
on the back guard are to be facing toward the front). Fasten back guard to
bench top with (5) screws and nuts (Items 2 & 3) as provided.
This completes the Back Guard assembly.
NOTE: The extra (2) screws and nuts are used when the end guards and
back guard are combined on the work bench.
End Guards and Back Guard Combined
Attach end guards and back guard to work bench as stated in the separate
assemblies for the end guards and back guard above. Flanges on back
guard are to be located inside of the end guards. Fasten end guards to back
guard with (1) screw and nut (Items 2 & 3) as provided, at each corner.
This completes the assembly for the End Guards and Back Guard
Combined.
Back Guard
Tools Required: 1. Phillips Screwdriver
2. 1/2" Open End or Box Type Wrench
Tools Required: 1. Phillips Screwdriver
2. 1/2" Open End or Box Type Wrench
~
END GUARD
(1 pr. required)
~
~
3