Instructions / Assembly

- 4 -

Shelf for Basic Work Bench

SHELF SUPPORT

FIGURE 10

Parts List "D"

Item Description Req'd.

1 Bench Shelf 1

2 .312 (5/16) - 18 x .500 (1/2) Phillips T.H.M.S. 4

3 .312 (5/16) - 18 Keps Nut 4

Place the shelf (Item 1) on the shelf supports between the legs of the work bench with the

back edge of the shelf (the edge with the 90° ﬂange is the back) approximately .062 (1/16")

from the back legs of the work bench. Position shelf so the two inner holes on each end of the

shelf are in line with the two inner holes of each shelf support. Fasten the shelf to the shelf

supports with (4) screws and nuts (Items 2 & 3) as provided, two each end. See Figure 10.

This completes the Shelf assembly for the Basic Work Bench.

Shelf for Continuous Bench with Common Leg

NOTE: Refer to Parts List "D" for parts required in this assembly.

1. Place the shelf (Item 1) on the shelf supports between the legs of the work bench with

the back edge of the shelf (the edge with the 90° ﬂange is the back) approximately .062

(1/16") from the back legs of the work bench. Position shelf so the two inner holes, in

the end of the shelf on the shelf support, are in line with the two inner holes of the shelf

support.

2. The two outer holes, in the shelf end that is on the common shelf support, are to be

aligned with the two inner holes in the common shelf support. See Figure 11. Fasten

shelf to the shelf supports with (4) screws and nuts (Items 2 & 3) as provided. Repeat

procedure with the other shelf on the other side of the common shelf support.

3. If more than two benches will be strung together in a continuous row, with a common

leg between each, the two outer holes in the shelf will always align with the respective

inner holes in the common shelf support.

This completes the Shelf assembly for the Continuous Work Bench with Common Leg.

SHELF SUPPORT

FIGURE 11

Tools Required: 1. Phillips Screwdriver

2. 1/2" Open End or Box Type Wrench