Installation Guide

All information is subject to change without notice Page 7 of 12
Borroughs Document Number: DOC-MDC-0011 Rev. 2.0
www.borroughs.com 1-800-748-0227
Shelf for Basic Workbench
STEPS
Place shelf on shelf supports between
legs of workbench with back edge of
shelf (edge with 90° flange is back)
approximately .062 (1/16”) from back
legs of workbench. Position shelf so two
inner holes on each end of shelf are in
line with two (2) inner holes of each shelf
support. Fasten shelf to shelf supports
with four (4) 07792-00 and 17213-00.
This completes assembly of shelf
assembly for basic workbench.
Shelf for Continuous Bench with Common Leg
Place shelf on shelf supports between legs of work bench with back edge of shelf (edge with 90° flange is
back) approximately .062 (1/16”) from back legs of work bench. Position shelf so two inner holes in end
of shelf on shell support, are in line with two inner holes of the shelf support.
The two outer holes, in shelf end that is on common shelf support, are to be aligned with two inner holes
in common shelf support. Fasten shelf to shelf supports with four (4) screws and nuts as provided. Repeat
procedure with other shelf on the other side of the common shelf support.
If more than two (2) benches will be strung together in a continuous row, with a common leg between
each, the two outer holes in shelf will always align with the respective inner holes in the common shelf
support. This completed the shelf assembly for the Continuous Work Bench with Common Leg.