Installation & Assembly

All information is subject to change without notice Page 11 of 12
Borroughs Document Number: DOC-MDC-0011 Rev. 2.0
www.borroughs.com 1-800-748-0227
Ledge Riser for Work Bench with End Guards and Back Guard
STEPS
Place ledge assembly on bench top flush against end
guards and/or back guard. The bottom oval in the sides of
ledge ends must align with hole in back corner of end
guards and/or hole in end flanges of back guard. Fasten
ledge assembly to end guards and/or back guard with one
(1) screw and nut as provided. If both end guards and a
back guard are on work bench, remove hardware holding
two (2) pieces together at each rear corner. Position ledge
assembly to align with the holes in guards as stated in the
beginning of this step and fasten ledge assembly to guards
with hardware originally provided. This completed the
assembly of Ledge Riser for the Work Bench Without End
Guards and Back Guard.
Portable Bench
STEPS
Place work bench upside down on a flat
clean surface.
Position heavy duty plate on adjustable foot.
The flange on heavy duty plate is to be
placed along front edge of adjustable foot.
Insert threaded stem of caster through holes
in heavy duty plate and the adjustable foot.
Fasten three (3) items together with one (1)
washer and nut as provided. Repeat
procedure with other three (3) adjustable
feet.
Adjust bench to desired height. Place unit in
upright position. This completes assembly of
the Portable Bench.