User manual

CLEANING THE HOSE AND NOZZLE

The vacuum cleaner stops automatically if the

nozzle, tube or hose becomes blocked, if the

filter and dust bag are blocked or if the overheat

indicator starts flashing (1). Disconnect from

the mains and allow the vacuum cleaner to cool

for 20-30 minutes.

Clear what is causing the stoppage and/or

replace dirty filters or the full BORK Clinic. Then

restart the vacuum cleaner.

Tubes and hoses

2. Use a cleaning strip or similar to clear the

tubes and hose.

3 It is sometimes possible to clear the hose by

“massaging” it. However, be careful in case

the obstruction has been caused by glass or

needles caught inside the hose.

Cleaning the floor nozzle

4. To avoid deterioration of suction power,

frequently clean the carpet/hard floor nozzle.

The easiest way to clean it is by using the

hose handle.

5 Press each wheel-hub and draw away the

wheels.

6 Remove dust-balls, hair or other objects that

may be entangled. Use the crevice nozzle to

clean the wheel axles.

Replace the wheels by pressing them into

position.

NOTE!

The warranty does not cover any damage to

hoses caused by cleaning them.

CARE AND CLEANING

BORK - VC SHB 9919 BK & VC SHB 916 16BORK - VC SHB 9919 BK & VC SHB 916 16 24.10.2006 11:45:0224.10.2006 11:45:02