User manual

12
GETTING THE BEST RESULTS
Hard floors: Use the carpet/hard floor nozzle
with the left pedal in position (1).
Carpets: Use the carpet/hard floor nozzle with
the left pedal in position (2).
Reduce suction power for small carpets.
Upholstered furniture: Use the combination
nozzle as shown in (3).
Curtains, lightweight fabrics, etc.: Use the
combination nozzle as shown in (3). Reduce
suction power if necessary.
Frames, bookshelves, etc.: Use the
combination nozzle as shown in (4) or feather
duster.
Crevices, corners, etc.: Use the extended
crevice nozzle (5). Extend the crevice nozzle
using a finger to push out the extending
section. When the extending section is in its
outermost position, a retaining button locks it
in position. Press this retaining button and push
the crevice nozzle together before placing it
back in the accessory holder.
Using the turbo nozzle: Attach the nozzle to
the tube (6). Adjust the suction power by
opening or closing the air vent (7).
21
3
4
5
6 7
NOTE!
Do not use turbo nozzle on skin rugs, rugs
with long fringes or a pile depth exceeding
15 mm. To avoid damaging the carpet, do not
keep the nozzle stationary whilst the brush is
rotating.
Do not pass the nozzle across electric cables,
and be sure to switch off the vacuum cleaner
immediately after use.
ASSEMBLING VACUUM CLEANER & OPERATION
ASSEMBLING VACUUM CLEANER & OPERATION
BORK - VC SHB 9919 BK & VC SHB 912 12BORK - VC SHB 9919 BK & VC SHB 912 12 24.10.2006 11:44:5924.10.2006 11:44:59