User`s guide

Chapter 10 Using Spline Media
532
If the point is a smooth point, adjust each handle separately by pressing the Alt key
while dragging the handle as shown in the following examples.
To convert a cusp or tangent point to a smooth point:
1. Select the point.
2. Do one of the following:
• Press the Ctrl key while clicking and dragging out from the control point.
• Select Tools > Smooth Points.
To convert a cusp point to a tangent point:
1. Select the point.
2. Press the Alt key while clicking and dragging out from the control point.
To remove a bézier handle from a tangent or smooth control point:
1. Select the point.
2. Do one of the following:
• Click the handle and drag it back into the control point.
• Select Tools > Cusp Points.
To reposition a control point:
1. Click to select the point.
2. Drag it to the desired location.