Operation Manual

Description of illuminated symbols
« AUTO » - (flashing) - Programmer in automatic position, but not programmed.
« AUTO » - (on steady) - Programmer in automatic position, with program inserted.
Automatic cooking operation
Timer in operation
and
« AUTO » (both flashing) – Programme error
No symbol on except for numbers on clock: programmer set in manual mode.
Digital clock
Indicates hours (0-24) and minutes.
Immediately after connection (as well as after a power outage), three intermittent numerals
are shown on the display.
To set the correct time, press:
+ : simultaneously and at the same time one of the [+]
or [-] buttons until you have the correct time.
The speed with which the numerals change on the display increases substantially a few
seconds after pressing the
[+] or [-] buttons.
Manual cooking
(without programmer)
To use the oven without the programmer, you will need to cancel the flashing «AUTO»
message
.
To do so, just press the  button.
If the «AUTO» message is steady, showing that the oven has been programmed, you will need
to cancel the programme by pressing
 so that the display shows zero.
Automatic cooking
(cooking start and stop)
1) Programme the length of cooking time with :.
2)
Programme the cooking stop time with .
3) Select the desired temperature and function using the thermostat commands and by
pressing the switch, the «AUTO» symbol on the display will indicate that the oven has been
programmed.
Practical example
:
As an example: you want to cook for 45 minutes, ending at 14.00.
- Press
 to set 0.45 on the display.
- Press
 to set 14.00 on the display.
After doing this, the display will once again show the current time and the «AUTO»
symbol, to indicate that your programming has been understood and memorized.
At 13.15 (14.00 less 45 minutes), the oven will start automatically, and during cooking
the symbols
 and «AUTO» will be shown.
At 14.00 the cooking will automatically stop, and a buzzer will sound, which can be
stopped by pressing
.
16