Operation Manual
54
GB
ATTENTION: certain recipes use pre-heating, so put the dish in when the
combimagnetron has reached the set temperature and the display shows “PRE-
HEATING FINISHED PUT IN THE DISH”
When cooking is nished the display will ash “PROGRAM FINISHED REMOVE THE
DISH” and, at the same time, the combimagnetron will beep until you press a key or
open the door.
Note: at any moment, if you make a mistake choosing the values and/or you want to change the settings of your
recipe, you can select which cancels it and allows you start over from the beginning of the procedure.
NOTE: If you are cooking with the modied parameters of a pre-set recipe, while the combimagnetron beeps at
the end of cooking, you will see:
see how to save recipes in the next paragraph.
PERSONALISING RECIPES
Once a pre-set recipe has nished, if you decide that the parameters must be changed for the results that you
want, you can change the recipe you used and save it for the next time by storing the new parameters used
(weight and cooking time).
To change the parameters of a preset recipe, do the following:
- with the + key select “YES”
- conrm with the key, the time used is displayed
- change with the + and - keys and conrm with , the weight used appears
- change with the + and - keys and conrm with , you will see the message “Recipe
saved POS. 1/1, and so on with a progressive number
Every time you access the “personal recipes” menu, you will ne your recipes saved in
the list of your recipes.
If there is not enough memory for saving personal recipes, the following message
appears on the display: “Insucient memory, impossible to save”.
Before saving your recipe, you must delete one
from the menu in this way:
- select the function;
- and then, by pressing go to the “personal
recipes” section where you will nd the saved
recipes;
- use the buttons to scroll through the menu and select the recipe you want to
delete.
NOTE: the names are given by default by the menu);