Operation Manual
41
GB
Setting the clock
The combimagnetron will signal that it is connected to the power mains with a double beep.
To set the system time, press the “TIMER FUNCTIONS” button for at least 3 seconds
Each command activated is conrmed by a beep.
Set the clock with the + and - buttons: during setting
the separator dots ash, the time has been set when the
dots remain steady on.
ACTIONS THAT ARE POSSIBLE WITH THE Combimagnetron OFF
- Turn on combimagnetron light
The combimagnetron light is turned on/o by touching
the symbol as shown in the gure.
- Change the Language
When the combimagnetron is o, you can change the language of the display by simultaneously selecting and
the + button in the lower right for at least 3 seconds.
Then use to select the language and conrm the choice with .