Operation Manual
36
GB
IMPORTANT
The combimagnetron’s identication plate is even accessible when the appliance is installed. This identication
plate, which is visible when you open the door, shows all the information you will need when requesting
replacement parts for the appliance.
FIRST USE
The combimagnetron should be thoroughly cleaned with soap and water and carefully rinsed.
Heat the combimagnetron for about 30 minutes at the maximum temperature; this eliminates all the residual
manufacturing oils that could cause unpleasant odours during cooking. Use the circular plus fan function without
accessories in the combimagnetron. Before using the accessories for the rst time, clean them carefully with a
very hot alkaline washing solution and a soft cloth.
ASSEMBLING AND DISASSEMBLING THE FLAT GRILL
To remove the at grill, pull the grill towards you until it stops and then lift, by pulling upwards, until it comes
completely out.
To put the at grill back in, insert it at a 45-degree angle and then position it horizontally and push it all the way
in to the end of the grill track.
If the at grill has a drip-pan (tray), to remove it, lift slightly and slide it towards you. To reinsert it, slide it back
until it is correctly seated.