Operation Manual
36
B200-B201-B202
Bernini
www.boretti.com
Gebruiksaanwijzing NL
Mode d’emploi FR
De Dollard 17, 1454 AT Watergang
T + 31 (0) 20 - 436 34 39, F +31 (0) 20 - 436 13 26
W www.boretti.com
E info@boretti.com
T +32 (0)3 450 81 80, F +32 (0)3 458 68 47
W www.boretti.be
E info@boretti.be
Boretti - The Netherlands
Boretti - Belgium
www.boretti.com
BORETTI0086 Cover Gebruiksaanwijzingen_v4.indd 3-4 06-11-15 16:33
« BEFORE THE FIRST USE
Disassembly
1. Take apart the parts of the pitcher. Loosen the mounting nut at
the bottom of the pitcher.
Tip: If this is dicult, place the pitcher on a surface with grip.
Press the pitcher down and turn the pitcher counterclockwise.
2. Wash all parts, following the instructions in the ‘Cleaning’
section.
3. When all of the parts are thoroughly dry, reassemble them.
Assembly
1. Place the pitcher upside down on a smooth surface.
2. Place the seal in the bottom opening of the pitcher.
3. Place the blades on the seal.
4. When placing the transparent plastic base, make sure that the
steel safety pin touches the steel on the work pitcher.
5. Finally, position the mounting nut. Fasten it by hand by turning
it clockwise.
« USE
1. Put the plug in the outlet.
2. Place the pitcher on the motor block with the handle facing the front, left or right.
3. Fill the pitcher with ingredients.
4. Place the lid on according to the gure below. Hook
the catch of the lid onto the pouring spout of the
pitcher and push the lid down. Push on the lock icon
to lock the lid. Place the measuring cup in the feed
tube, positioning the thicker sections on the cup in the
recesses. Lock it in by turning it clockwise.
5. Press the switch to the on position. All indication lights
will turn on.
6. Press the button of the desired speed and release it.
The indication light of the button selected will light up.
7. To stop blending, press the button of the selected
speed again.
8. Wait until the blades have stopped turning before
removing the pitcher.
9. Remove the lid by raising the tab of the lock.
Caution: the blender is very powerful. This allows the
ingredients to mix faster than with a standard blender.
To prevent overheating, when using the blender for long periods (10 cycles), it is best to allow
it to cool to room temperature rst One cycle is 3 minutes on and 1 minute o.
7
6