User Manual
EN
30
Decommissioning, disassembly and disposal
www.bora.com
9  Decommissioning, disassembly and disposal
9.3  Environmentally-friendly 
disposal
Disposal of transport packaging
 i
The packaging protects the device from damage in 
transport. The packaging materials have been selected 
from environmental and disposal perspectives and are 
therefore   recyclable.
Returning the packaging to the materials cycle saves resources 
and reduces waste volumes. Your specialist supplier will take the 
packaging back.
XX
Give the packaging to your specialist supplier
or
XX
Dispose of the packaging properly in line with local 
regulations.
Disposal of old appliance
Electrical devices marked with this label 
may not be disposed of in domestic waste 
at the end of their service life. They must 
be disposed of at a collection point for 
the recycling of old electrical or electronic 
devices. You can find information from your 
city or district council.
Many electrical and electronic devices still contain valuable 
materials. But they also contain damaging materials which 
were necessary for them to function properly and safely. These 
can damage human health or the environment if disposed of 
improperly or incorrectly handled.
XX
Never put your old appliance in domestic waste.
XX
Take the old appliance to a regional collection point for return 
and recycling electrical and electronic components and other 
materials.
XX
Observe all safety and warning information 
(see the Safety section).
XX
Follow the enclosed manufacturer’s information.
9.1  Decommissioning
Decommissioning is understood as final shutdown and 
disassembly. Following decommissioning, the device can either 
be installed into other units, sold on privately or disposed of.
 i
Electricity and gas connections may only be disconnected 
by qualified specialists.
XX
To decommission, switch the device off 
(see Operation section)
XX
Disconnect the device from the power supply.
9.2  Disassembly
For removal, the device must be accessible for disassembly and 
disconnected from the power supply. 
XX
Undo the appliance fixture.
XX
Remove the silicone joints.
XX
Remove the device from the worktop by lifting it upwards.
XX
Remove any other accessories.
XX
Dispose of the old device and any contaminated accessories 
as described under “ Environmentally-friendly disposal”.










