User Manual

EN
18
Installation
www.bora.com
5.7.1 Installing the cooktop
Inserting the Tepan stainless steel grill PKT3 (ports
on the back)
321
Fig. 5.16 Inserting the cooktop
[1] Worktop cut-out
[2] Tepan stainless steel grill
[3] Control knob and automatic extractor function ports
XX
Insert the Tepan stainless steel grill [2] into the worktop cut-
out [1].
XX
Precisely align the Tepan stainless steel grill [2].
XX
For a normal installation, please note that the ports for the
control knobs and the automatic extractor function [3] are at
the rear.
Levelling the cooktop (if necessary)
1
2
Fig. 5.17 Cooktop and height adjustment plates
[1] Cooktop
[2] Height adjustment plates
XX
If applicable, insert the height adjustment plates [1].
Fig. 5.14 Fitting the control knob
Fig. 5.15 Wave spring when installation is complete
XX
Remove the knob ring [4].
XX
Unscrew the universal nut [2].
XX
Remove the wave spring [5].
XX
Insert the knob housing [1] from the front through the hole in
the panel.
XX
Attach the wave spring [5] to the knob housing [1] from the
rear (not in the case of steel fronts).
XX
Screw the universal nut [2] onto the knob housing [1] from the
rear and tighten a little.
XX
Align the knob housing [1] so it is level.
XX
Tighten the universal nut [2].
XO
The wave spring (if used) must be pressed flat.
XX
Remove the sticker [3].
XX
Place the knob ring [4] on the knob housing [1].
5.7 Installing the cooktops
i
Clearance of one millimetre should be planned between
the built-in appliances.
i
A clearance of two millimetres should be planned around
the built-in appliances.
i
It is recommended to install a mounting rail between
adjacent cooktops (mounting rail PZMS available as an
accessory).
i
The cooktop can also be installed rotated by 180°.