User's Manual

EN
22
Installation
www.bora.com
Connecting the cooking zones when the cooktop is
installed rotated by 180°
5 4
3
2
1
7
6
Fig. 5.20 Cooking zone connection in 180° installation
[1] Cooktop
[2] Rear cooking zone (zone 1)
[3] Front cooking zone (zone 2)
[4] Rear cooking zone control knob (zone 1)
[5] Front cooking zone control knob (zone 2)
[6] Front cooktop display (zone 2)
[7] Rear cooktop display (zone 1)
 Connect the connection on the back of the left control
knob [5] to the “zone 2” connection on the back of the
cooktop [1].
 Connect the connection on the back of the right
control knob [4] to the “zone 1” connection on the
back of the cooktop [1].
 Using the configuration menu, set the correct
allocation of the cooking zones in the control
knob display (see Configuration menu, 0° or 180°
installation).
Connecting the automatic extraction system
2
ZONE1 INTERF. COM1 ZONE2
1
ZONE1 INTERF. COM1 ZONE2
3
Fig. 5.21 Connection of the automatic extraction system
[1] Connection of the automatic extraction system (cooktop
extractor)
[2] Connection of the automatic extraction system (cooktop)
[3] Automatic extraction system cable
 Connect the cooktop extractor [1] to the cooktop using
the connector provided for the automatic extraction
system [2].
5.5.5 Establishing the power connection
 Observe all safety and warning information (see the
Safety chapter).
 Observe all national and regional laws and regulations
as well as the supplementary regulations of the local
utility companies.
INFO The power connection may only be established by
certified specialists. The specialist also assumes
responsibility for the proper installation and
commissioning.
The power supply line to be used (pre-assembled) must
be at least type H05VV-F or H05VVH2-F (see table Fuse
protection and minimum cross-section).
Connection Fuse protection Minimum
cross-section
1-phase connection 1 x 16 A
1.5 mm²
2.5 mm² in Australia and
New Zealand (AUS/NZS)
Tab. 5.4 Fuse protection and minimum cross-section

If the connection cable has been damaged this must
be replaced. This may only be done by an authorised
member of the After Sales Service team.