User Manual - 2
EN
25
Installation
www.bora.com
Fig. 6.32 Sealing tape position for installation with a round duct
Depending on the required connection cross-section,
you can vary the height at which the sealing tape is
attached to the plinth fan inlet nozzle.
INFO If another universal fan module is to be used, it
must also be prepared with sealing tape on the
inlet nozzles as described here.
Fig. 6.33 Applying seal to the inlet nozzles of the plinth fan.
Push the seal onto the outlet nozzles of the plinth fan.
This means stretching the seal slightly.
2
1
Fig. 6.31 Dismounting the cover frame
[1] cover frame
[2] Cooktop extractor
Rotate the cooktop extractor [2] and remove the cover
frame [1].
Rotate the cover frame [1] by 180°.
Replace the cover frame [1] back on the cooktop
extractor [2].
Make sure that the holding clamps slot into place.
6.8 Installing the duct system
6.8.1 Preparing for installation
INFO The floor unit must not be supported on the plinth
fan housing.
INFO For correct installation, the slide-in units of the
base cabinet must be shortened depending on the
installation situation.
INFO When fitting the seals, make sure it fits and forms
an air-tight seal with the connection duct piece
when compressed.
Adjust the ducting parts to the height of the worktop.
Saw out the necessary cut-outs for the ducting in the
rear panel of the floor unit.
Preparing for installation of cooktop extractor
PKA
Depending on the installation situation, adjust the
levelling feet on the floor unit as necessary.
Prepare the plinth fan by attaching the sealing tape
depending on the installation situation.
Secure the sealing tape to the inlet nozzle.