User Manual - 2

Installation

www.bora.com

 If necessary, shorten the mounting clamps in line with

the worktop thickness.

 To do this, cut the mounting clamps at the appropriate

cut marks using a cutter.

 Depending on the installation type, twist the mounting

clamps to the left or right (flush mounting or surface

mounting).

Securing the cooktop extractor

INFO The cooktop extractor is secured using the four

mounting clamps provided, for which there are 4

alternative positions on the holding plate.

23 1

Fig. 6.13 Push on mounting clamps

[1] Alternative position for mounting clamp

[2] mounting clamp

[3] Cooktop extractor

 Push the mounting clamps [2] into the holders

provided on the cooktop extractor [3] or the alternative

positions on the holding plate [1].

Preparing the mounting clamps

Fig. 6.11 Mounting clamp on right (ush mounting)

[1] Worktop thickness labelling (in mm)

[2] Cut mark (4x)

[3] Fastening lugs (2 on each side)

[4] Marking for flush mounting

Fig. 6.12 Mounting clamp on left (surface mounting)

[1] Worktop thickness labelling (in mm)

[2] Cut mark (4x)

[3] Fastening lugs (2 on each side)

[4] Marking for surface mounting

INFO The symbols on the mounting clamps show which

side to use for surface mounting and for flush-

mounting.

INFO The labels shows the cutting mark to go with the

worktop thickness.