User Manual - 2

EN
19
Installation
www.bora.com
1
2
Fig. 6.9 Height adjustment plates
[1] Height adjustment plate
[2] Cooktop extractor
 If applicable, insert the height adjustment plates [1].
0,5
21 1
Fig. 6.10 Installing the cooktop extractor
[1] Cooktop
[2] Cooktop extractor

The cooktop extractor [2] must be installed 0.5 mm
higher than the cooktops [1].
6.5.3 Securing the cooktop extractor
The cooktop extractor is secured using the four mounting
brackets provided. The mounting brackets have offset
fastening lugs, with one side for surface mounting and
one for flush mounting. The mounting clamps can be
adjusted to the thickness of the worktop.
6.5 Installing the cooktop extractor
INFO Clearance of one millimetre should be planned
between the built-in appliances.
In combination with an adjacent PKIW1 induction
wok cooktop, the plastic strip on the side of the
cooktop extractor must be carefully removed for
this.
INFO A clearance of two millimetres should be planned
around the built-in appliances.
6.5.1 Installation dimensions
≥700
≥900
≥74
Fig. 6.7 PKA, PKAS and PKASAB device installation dimensions
6.5.2 Fitting the cooktop extractor
1
2
Fig. 6.8 Fitting the cooktop extractor
[1] Worktop cut-out
[2] Cooktop extractor
 Place the cooktop extractor [2] in the middle of the
relevant worktop cut-out [1].
 Precisely position the cooktop extractor [2].