Installation and Operation Guide

EN
21
Installation
www.bora.com
The power supply line to be used (pre-assembled) must
be at least Type SiHF.
(see table Fuse protection and minimum cross-section.
Connection Fuse protection Minimum
cross-section
1-phase connection 1 x 25 A
2.5 mm²
2-phase connection 2 x 16 A
2.5 mm²
Tab. 5.4 Fuse protection and minimum cross-section

If the connection cable has been damaged this must
be replaced. This may only be done by an authorised
member of the After Sales Service team.
 Switch off the main switch/automatic circuit breaker
before connecting the cooktop.
 Secure the main switch/automatic circuit breaker
against being switched back on without permission.
 Make sure the power to the appliance is disconnected.
 Only connect the cooktop using a permanent
connection to a power supply cable.
1
L1 L2
2
N PE
220 - 240 V~
220 - 240 V~
3
Fig. 5.22 Connection diagram 2-phase
1
L1
2 3
N PE
220 - 240 V~
Fig. 5.23 Connection diagram 1-phase
 Check that installation has been carried out correctly.
 Switch on the main switch/automatic circuit breaker.
 Put the cooktop into operation (see the Operation
chapter).
 Check that all the functions are working correctly.
5.6 Configuration menu
Once installation is complete, you can adjust the basic
settings for the cooktop. These can then be changed at
any time.
5.6.1 Accessing the configuration menu
 Turn the control knob to the 11 o’clock position.
The control knob display shows
t
.
 Press the touch surface of the control knob for one
second. The display changes to
0
0
0
.
 Press the touch surface again within 3 seconds and
hold for 5 seconds.

The control knob display shows
C
, a beep is heard and
the configuration menu is available.
5.6.2 Select menu option
 Turn the knob ring to select the menu option you want.
The following menu options are available:
Menu options
C
0
Warning beep volume
C
1
Select operating mode (normal operation or demo mode)
C
2
0° or 180° installation
C
3
Control knob display type
C
9
Availability of the pause function
Tab. 5.5 Menu options in the conguration menu
 Touch the touch surface on the control knob again for
1 second to confirm the menu you want.

The sub-menu is accessed and the display switches to
a three-character combination (e.g.
C
2
3
).
INFO In the three-character combination shown, the
right-hand figure shows the value saved in the
system.
Setting the volume of the warning beep
Once you have confirmed menu option
C
0
, you can set
the volume of the warning beep.
Setting Warning beep volume
C
0
0
100% (max. volume) Factory setting
C
0
1
10% (min. volume)
C
0
2
20%
C
0
3
30%
C
0
4
40%
C
0
5
50%
C
0
6
60%
C
0
7
70%
C
0
8
80%
C
0
9
90%
Tab. 5.6 Warning beep volume