Installation and Operation Guide

EN
20
Installation
www.bora.com
 Connect the connection on the back of the left control
knob [5] to the “zone 2” connection on the back of the
cooktop [1].
 Connect the connection on the back of the right
control knob [4] to the “zone 1” connection on the
back of the cooktop [1].
Connecting the cooking zones when the cooktop is
installed rotated by 180°
5 4
3
2
1
Fig. 5.20 Cooking zone connection in 180° installation
[1] Cooktop
[2] Rear cooking zone (zone 2)
[3] Front cooking zone (zone 1)
[4] Rear cooking zone control knob (zone 2)
[5] Front cooking zone control knob (zone 1)
 Connect the connection on the back of the left control
knob [5] to the “zone 1” connection on the back of the
cooktop [1].
 Connect the connection on the back of the right
control knob [4] to the “zone 2” connection on the
back of the cooktop [1].
 Using the configuration menu, set the correct
allocation of the cooking zones in the control
knob display (see Configuration menu, 0° or 180°
installation).
Connecting the automatic extraction system
2
ZONE1 INTERF. COM1 ZONE2
1
ZONE1 INTERF. COM1 ZONE2
3
Fig. 5.21 Connection of the automatic extraction system
[1] Connection of the automatic extraction system (cooktop
extractor)
[2] Connection of the automatic extraction system (cooktop)
[3] Automatic extraction system cable
 Connect the cooktop extractor [1] to the cooktop using
the connector provided for the automatic extraction
system [2] .
5.5.5 Establishing the power connection
 Observe all safety and warning information (see the
Safety chapter).
 Observe all national and regional laws and regulations
as well as the supplementary regulations of the local
utility companies.
INFO The power connection may only be established by
certified specialists. The specialist also assumes
responsibility for the proper installation and
commissioning.
INFO This appliance is intended to be operated on
a supply network with an impedance Zmax at
the transfer point (mains connection) of 0.104
ohms maximum. The user is to ensure that the
appliance is only operated on a mains supply
network which meets this requirement. If
necessary, ask the local energy supply company
about the system impedance.