Installation and Operation Guide

EN
17
Installation
www.bora.com
 Pull off the knob ring [3].
 Unscrew the universal nut [2].
 Pull off the wave spring [4].
 Push the knob casing [1] through the hole in the panel
from the front.
 Push the wave spring [4] onto the knob casing [1] from
the rear (not with steel fronts).
 Screw the universal nut [2] onto the knob casing [1]
from the rear and tighten a little.
 Use the marking to align the knob casing [1] vertically
in the 12 o’clock position.
 Tighten the universal nut [2].
 The wave spring (if used) must be pressed flat.
 Slot the knob ring [3] onto the knob casing [1] and
align it to the 12 o’clock position.
Example bore holes
≥40≥70
90 90 90
Ø50 ±0,5
90 196 196
370 370
110
1 1
Fig. 5.12 Bore holes for 2 cooktops and 1 cooktop extractor
[1] Boreholes for socket (2x external)
[2] Bore holes for control knobs (5x)
[3] Cooktop (2x)
[4] Cooktop extractor
[5] Worktop
[6] Floor unit front panel
3
4
2
1
Fig. 5.9 Structure of control knob
[1] Knob casing
[2] Universal nut
[3] knob ring
[4] Wave spring
INFO The wave spring must not be used with steel
fronts. The relevant assembly steps should simply
be skipped.
Fig. 5.10 Fitting the control knob
Fig. 5.11 Wave spring once assembly is complete