Use and Care Manual

Assembly Instructions:
WARNING: Ensure your mounting location is capable of withstanding the
additional load. Never overload your rack. Note: Vertical bars can be used
as templates to mark your drilling locations before assembly.
1. Locate the bottom of the long vertical bar. It has a small screw hole 1/2
inch (13mm) from the end. Insert a screw A. Locate the bottom of an
orange horizontal bar B. It has a small notch as shown in the inset photo.
Slide the orange bar down the length of the vertical bar from the top until
it rests in position against the screw. Figure 1.
2. Insert a screw into the next hole up, then slide another orange bar into
position. Continue this process until all the bars are fitted, being careful
that all the notches face down. Repeat this process for the other side.
Figure 2.
Note: Alternative rack positions can be achieved by drilling additional
holes where desired using a 5/32" (4mm) drill bit.
3. Installing to drywall or other paneled wall sheeting: Locating a solid
structural support for your Portamate Wood Rack is very important.
Ensure that you are securely contacting the center of the wall studs.
Distance between the vertical bars is optional. The recommended distance
to support the designed weight capacity is 4 – 6 ft. (120 - 180 cm). For
longer material or greater weight, multiple wood racks can be used.
Figure 3. The assembled Wood Rack is 1-5/8" (41mm) thick so a suitable
length of fastener is 3" (76mm) and 1/4" (6mm) diameter.
Congratulations!
You have just purchased a Portamate Wood
Rack. The Portamate Wood Rack is a compact
storage system designed to help you organize
your workshop. It can be used for a variety of
materials including timber, moldings, pipes, PVC
and more. Applications include garage walls,
basements, sheds, and even outdoor fences.
• TheWoodRackprovides5levelswitha
capacity of 110 lb. (50 kg.) per level. It is
easy to install and easy to customize.
• Duetoproductimprovements,actual
product may vary slightly. Made in China.
1 Year warranty.
NOTICE: Assembly hardware located in
tubes at end of package
Figure 1
Figure 2
Figure 3
B
A
D
PBR001
Description Part No.
A Screws (12) S002
B Horizontal Bars (12) SH003
C Spacers (6) S001
D Vertical Bars (2) SV004
PBR002
Description Part No.
A Screws (10) S002
B Horizontal Bars (10) SH003
C Spacers (6) S001
D Vertical Bars (2) SV004
*PBR001 shown.
Other models
may vary slightly.
2