Installation Guide

EN
7
Safety
www.bora.com
CAUTION!
Lifting heavy loads can cause back
injuries!
If not handled correctly, removing and
installing the appliance can cause
injuries to the limbs or torso.
 Removing the cooktop from the
packaging is a two-person job.
 Placing the cooktop into the worktop
cut-out is a two-person job.
 Use appropriate aids to prevent
damage or injuries to limbs or torso.
Special safety information for gas cooktops
The gas connection may only be carried out
by an authorised gas fitter in accordance with
applicable legal regulations. Comply with local
utility company regulations.
 The appliance is not suitable for installation or
operation with accessories or components
from third party suppliers.
DANGER!
Risk of explosion from gas!
Gas leaks can cause explosions and
serious injuries.
 Keep ignition sources (naked flames,
heaters) away.
 Close the gas supply and turn off the
mains supply.
 Plug any leaks immediately.
DANGER!
Risk of asphyxiation!
Packaging components (e.g. lm,
polystyrene) can be life-threatening for
children.
 Store all packaging components out
of reach of children.
 Dispose of the packaging properly
and immediately.
2.2.1 Safety information for cooktop
installation
DANGER!
Risk of electric shock!
Connecting the appliance to the mains
incorrectly poses a risk of electric
shock.
 Make sure that the appliance has a
fixed connection to the mains
voltage.
 Make sure that the appliance is
connected to a properly installed
protective conductor system.
 Make sure that technical equipment
is provided to enable all of the
appliance’s poles to be disconnected
from the mains with a contact
opening width of at least 3 mm (LS
switch and automatic circuit
breakers, fuses, contactor).
DANGER!
Risk of electric shock!
The connection cable can be damaged
if it comes into contact with hot
cooking zones. A damaged connection
cable can cause a (fatal) electrical
shock.
 Make sure that the connection cable
does not come into contact with hot
cooking surfaces.
 Make sure that the connection cable
does not become trapped or
damaged.