User's Manual

EN
38
Cleaning and Maintenance
www.bora.com
 Position the burner head [2] correctly on the gas
outlet.
 Ensure that the safety thermocouple [4] and the
electric igniter [3] are positioned in the correct
opening.
 Position the burner cap [1] so that it fits perfectly,
sitting straight on the burner head [2].

If burner parts are not positioned correctly, the electric
igniter will not work.
 Place the pan support straight on the gas burner so it
fits perfectly.
 Put the gas burner into operation (see the Operation
chapter).
7.4 Cleaning the control knobs
12
3
Fig. 7.3 Pull out the knob ring
[1] Knob casing
[2] Touch surface
[3] Knob ring
7.4.1 Cleaning the knob ring
The knob ring can only be cleaned by hand.
 Remove the knob ring from the knob housing.
 Use a cleaner and degreaser in one.
 Rinse the knob ring with hot water.
 Clean the knob ring with a soft brush.
 Rinse the knob ring well after cleaning.
 Dry the knob ring carefully.
 Place the dry knob ring back on the knob housing.
 Make sure it is positioned correctly (0 position).
 If necessary, turn the knob ring to the 12 o’clock
position (= 0 position).
7.4.2 Cleaning the touch surface and the
knob housing
 Remove the knob ring.
 Clean the touch surface and the knob housing with a
soft, damp cloth.
 Dry the touch surface and the knob housing carefully.
 Place the knob ring back on the knob housing.
INFO If the knob ring has not been fitted correctly, a
segment rotating clockwise is displayed in the
central control knob display ( ).