User's Manual

EN
28
Installation
www.bora.com
Total nominal connection values for natural gas:
Gas type mbar kW m³/h
G20 20 5,00 0,449
G25 25 5,10 0,538
G25.3 25 5,10 0,538
G20 13 5,10 0,486
G25 20 4,80 0,501
Tab. 5.8 Total nominal connection values for natural gas
5.7 Configuration menu
Once installation is complete, you can adjust the basic
settings for the cooktop. These can then be changed at
any time.
5.7.1 Accessing the configuration menu
 Turn the control knob to the 11 o’clock position.
The control knob display shows
t
.
 Press the touch surface of the control knob for one
second. The display changes to
0
0
0
.
 Press the touch surface again within 3 seconds and
hold for 5 seconds.

The control knob display shows
C
, a beep is heard and
the configuration menu is available.
5.7.2 Select menu option
 Turn the knob ring to select the menu option you want.
The following menu options are available:
Menu options
C
0
Warning beep volume
C
1
Select operating mode (normal operation or demo mode)
C
2
0° or 180° installation
C
3
Configuration of gas type and gas pressure
C
4
Characteristic curves
C
5
GPU reset
C
9
Availability of the pause function
Tab. 5.9 Menu options in the conguration menu
 Touch the touch surface on the control knob again for
1 second to confirm the menu you want.

The sub-menu is accessed and the display switches to
a three-character combination (e.g.
C
2
3
).
INFO In the three-character combination shown, the
right-hand figure shows the value saved in the
system.
Setting the volume of the warning beep
Once you have confirmed menu option
C
0
, you can set
the volume of the warning beep.
Setting Warning beep volume
C
0
0
100% (max. volume) Factory setting
C
0
1
10% (min. volume)
C
0
2
20%
C
0
3
30%
C
0
4
40%
C
0
5
50%
C
0
6
60%
C
0
7
70%
C
0
8
80%
C
0
9
90%
Tab. 5.10 Warning beep volume
Select operating mode
Once you have confirmed menu option
C
1
, you can select
the operating mode.
Setting Operating mode
C
1
0
Normal operation Factory setting
C
1
1
Demo mode
Tab. 5.11 Operating modes
INFO All the control knob functions are available in
demo mode. The heating function for the cooktop
is deactivated. Demo mode is used, for example,
for exhibitions.
0° or 180° installation
In menu option
C
2
, you can set whether the cooktop is
installed rotated by 180°.
Setting Display
C
2
0
0° installation Factory setting
C
2
1
180° installation
Tab. 5.12 Installation direction
INFO For installation rotated by 180°, the setting
C
2
1
correctly assigns the correct cooking zones inside
the control knob display.
Configuration of gas type and gas pressure
Under menu option
C
3
the minimum power of each
burner and gas type/pressure is regulated.
INFO Correct selection is important for the safe,
problem-free operation of the gas cooktop.
INFO Factory setting
C
3
0