User's Manual

EN
21
Installation
www.bora.com
Fig. 5.13 Fitting the control knob
Fig. 5.14 Wave spring once assembly is complete
 Pull off the knob ring [3].
 Unscrew the universal nut [2].
 Pull off the wave spring [4].
 Push the knob casing [1] through the hole in the panel
from the front.
 Push the wave spring [4] onto the knob casing [1] from
the rear (not with steel fronts).
 Screw the universal nut [2] onto the knob casing [1]
from the rear and tighten a little.
 Use the marking to align the knob casing [1] vertically
in the 12 o’clock position.
 Tighten the universal nut [2].
 The wave spring (if used) must be pressed flat.
 Slot the knob ring [3] onto the knob casing [1] and
align it to the 12 o’clock position.
5.5.1 Installing the control knob in the floor
unit front panel
INFO Pre-drill the bore holes to prevent tearing out the
fixed front panel.
Fig. 5.10 Installed control knob and cooktop
≥40≥70
Ø50 ±0,5
370
80-140
Fig. 5.11 Drill template
3
4
2
1
Fig. 5.12 Structure of control knob
[1] Knob casing
[2] Universal nut
[3] knob ring
[4] Wave spring
INFO The wave spring must not be used with steel
fronts. The relevant assembly steps should simply
be skipped.