Installation Guide

EN
33
Installation
www.bora.com
XX
Unscrew the gas burner nozzle [2] from the gas burner [1]
XX
Screw the corresponding nozzle for the gas type to be used
into the gas burner [2].
XX
Put the burner parts back together again.
XX
Position the burner head [2] correctly on the gas outlet.
XX
Ensure that the safety thermocouple [4] and the electric
igniter [3] are positioned in the correct opening.
XX
Position the burner cap [1] so that it fits perfectly, sitting
straight on the burner head [2].
XO
If burner parts are not positioned correctly, the electric igniter
will not work.
XX
Place the pan support straight on the gas burner so it fits
perfectly.
Affixing the nozzle set nameplates
XX
Affix the nozzle set nameplates supplied in the space provided
above the nozzle nameplate on the bottom of the cooktop
(see fig. 4.46) and on the inside of the back cover of the
operating instructions.
Fig. 4.46 A󹨩xing the nozzle set nameplates
4.14.6 Gas configuration
i
The burner nozzles, gas type and pressure may only
be changed by a certified engineer or BORA service
technician. He/she also assumes responsibility for the
proper gas installation and commissioning.
i
Gas characteristic curve A must not be used in the case
of liquid gas (G30/31).
i
It is important that the gas type, gas pressure and
characteristic curve are set correctly to ensure safe,
failure-free operation of the gas cooktop.
i
Detailed information on the gas configuration menu can
be seen in the operating instructions.
XX
Enter the settings in the gas configuration menu (see
operating instructions, Extended menu chapter).
Total nominal connection values for U-LPG/
2.75 kPa test point pressure: 18.6 Mj/h
Cooktop energy consumption AU/NZ – U-LPG/
2.75 kPa test point pressure:
High Power front burner 11.2 Mj/h
Normal back burner 7.4 Mj/h
Total nominal connection values for NG/
1.0kPa test point pressure: 19.5 Mj/h
Cooktop energy consumption AU/NZ – NG/
1.00 kPa test point pressure:
High power front burner 12.0 Mj/h
Normal back burner 7.5 Mj/h
1
2
3
4
5
6
Fig. 4.44 Gas burner structure
[1] Burner cap
[2] Burner head
[3] Electric igniter
[4] Safety thermocouple
[5] Burner housing
[6] Gas burner nozzle
XX
Remove the pan support.
XX
Remove the burner cap [1] from the burner head [2].
XX
Remove the burner head [2] from the gas outlet.
1
2
Fig. 4.45 Cooktop burner with gas burner nozzle
[1] Gas burner
[2] Gas burner nozzle