User Manual

EN
36
Operation
www.bora.com
6.5.4 Automatic heat up function
INFO The system automatically determines the heating
time depending on the power level set.
Activating the automatic heat up function
 Tap the required cooking zone
 Setting the power level (= continuous cooking level)
 Tap the heat-up button

The automatic heat up function is activated.

The automatic heat up function symbol is shown
next to the cooking zone.
INFO If the cooking zone power level is increased while
the automatic heat up function is active, the
automatic heat up function remains active. The
heating time is adjusted accordingly.
INFO If the cooking zone power level is decreased
while the automatic heat up function is active, the
automatic heat up function is deactivated.
Deactivating the automatic heat up function early
 Tap the required cooking zone
 Long press on the heat-up button

The automatic heat up function is deactivated.

The cooking zone changes back to the previously set
power level.
Time lapsed

When the heat up time has lapsed, the previously set
continuous cooking level will be activated.

The heat-up symbol will no longer be displayed.
6.5.5 Power setting
INFO If a cooking zone on one of the cooktops is
operated on the power setting, the second
cooking zone can be operated on power level 5
at most (exception: on the appliances CKG and
CKT the power setting can be activated for both
cooking zones).
INFO If a higher level than 5 is set on the second
cooking zone when the power setting is activated,
the level will automatically be reduced to power
level 5.
INFO If a power level higher than 5 is set for the second
cooking zone, the active power setting on the first
cooking zone will be automatically switched back
to the previous level.
Power-level adjustment on the Tepan
stainless steel grill CKT
INFO The Tepan stainless steel grill power levels are
shown in the corresponding cooking zone display
as a 7-segment font (
1
-
9
,
ßp
).
When a cooking zone is selected the temperature
is shown in °C in the multi-function display above
the slider (temperature indicator).
INFO During the initial heating phase the actual
temperature is shown in the multi-function display
until the target temperature is reached in the
selected cooking zone.
Increasing the temperature
 Tap the required cooking zone
 Swipe upwards to the required target temperature
or
 tap until the required target temperature is reached
or
 tap a higher position on the slider
or
 long press on (power level is increased in threes: 0,
3, 6...)
INFO During the heating phase the red hot button
flashes, even if the operating panel display
changes to the standard display after 3.5
seconds. When the target temperature is reached,
it stops flashing.
Lowering the temperature
 Tap the required cooking zone
 Swipe downwards to the required temperature
or
 tap until the required temperature is reached
or
 tap a lower position on the slider
or
 long press on (power level is decreased in threes:
... 6, 3, 0)
6.5.3 Switching off the cooking zone
 Tap the required cooking zone.
 Swipe right down to the bottom until
0
appears in the
cooking zone display.
or
 tap until
0
appears in the cooking zone display.

The residual heat indicator
H
will then appear.
Switching off a cooking zone quickly (Quick Off)
 Long press on the cooking zone

A longer acoustic signal provides confirmation.

The residual heat indicator
H
appears in the cooking
zone display if necessary. If there is no residual heat,
0
is immediately displayed.