User Manual

EN
35
Operation
www.bora.com
6.5.2 Setting cooking zone power levels
INFO The cooking zone power levels are shown in
the corresponding cooking zone display as a
7-segment font.
The cooking zone power levels can be adjusted in
different ways:
 tap on or
 adjustment using the slider
 by tapping a certain position on the slider
 long press on or (adjustment in threes)
Additional instructions for gas cooktop CKG:
INFO After setting a power level, gas cooktop CKG is
automatically ignited and the cooking zone is
operated at the set power level.
INFO The ignition process happens several times in
succession and generates a typical clicking noise.
INFO If it does not ignite, the procedure can be
repeated. When the desired cooking zone is
selected and the power level is set, the cooktop is
automatically reignited.
Power-level adjustment on cooktops CKFI,
CKI, CKIW, CKCH, CKCB and CKG
Increasing the power level
 Tap the required cooking zone
 Swipe upwards to the required power level
or
 tap until the required power level is reached
or
 tap a higher position on the slider
or
 long press on (power level is increased in threes: 0,
3, 6...)
Reducing the power level
 Tap the required cooking zone
 Swipe downwards to the required power level
or
 tap until the required power level is reached
or
 tap a lower position on the slider
or
 long press on (power level is decreased in threes:
... 6, 3, 0)
INFO If after setting a power level on induction
cooktops CKFI, CKI and CKIW no suitable
cookware is detected (pan size recognition) within
9 minutes, the corresponding cooking zone will be
automatically switched off.
6.5 Operating the cooktops
INFO To be able to operate the cooktops, cooktop
operation must be active in the operating panel
(colour mode “red”).
INFO If no commands are entered within 3.5 seconds
when the cooktop operating panel is active,
the system automatically switches back to fan
operation (standard display).
6.5.1 Selecting cooking zones
INFO With this system you can operate and control up
to 4 cooking zones at the same time.
 Tap on a cooking zone.

The system changes to colour mode “red”.

The system switches to the power display.

The additional cooking zone functions appear.

Cooking zone operation is activated and you can make
settings for the chosen cooking zone.
 Repeat this process to operate further cooking zones if
necessary.
INFO A cooking zone can be switched off early by
a further touch command in the cooking zone
display. The system then immediately switches to
fan operation.
Changing to another cooking zone
INFO When you are in cooktop operating mode (colour
mode “red”) and adjust the settings for one
cooking zone, you can immediately change over to
and operate another cooking zone.
 Tap another cooking zone within 3.5 seconds.

The cooking zone lights up in the operating panel
display.

Operation of the second cooking zone is activated.

The first cooking zone is dimmed in the operating
panel display and the previous settings are adopted.