EN Operating and installation instructions CIW1 Induction glass ceramic wok CIW1UMEN-002 www.bora.
Operating and installation instructions: Original Translation Manufacturer BORA Vertriebs GmbH & Co KG Innstraße 1 6342 Niederndorf Austria Contact T +43 (0) 5373 / 62250-0 mail@bora.com www.bora.com The distribution and duplication of this document, as well as the use and disclosure of its contents are prohibited unless expressly authorised. These operating and installation instructions have been drawn up with the greatest of care.
EN Table of Contents 1 General information 4 2 Safety 6 1.1 1.2 1.3 1.4 Target group.................................................................4 Validity of the operating and installation instructions....4 Other applicable documents.......................................4 Presentation of information.........................................5 7 Cleaning and M aintenance 21 8 Troubleshooting 22 Decommissioning, disassembly and disposal 23 7.1 7.2 7.3 Cleaning agents..............
General information EN 1 General information 1.1 Target group INFO These operating and installation instructions apply for the following target groups: Target group Requirements User The appliance can be used by children aged 8 and above as well as people with reduced physical, sensory or mental capacities or a lack of experience and/or knowledge if they are supervised or have been instructed how to safely use the appliance and understand the resultant risks. Children must be supervised.
General information 1.4 EN Presentation of information To make working with these instructions quick and easy, consistent formatting, numbering, symbols, safety instructions, terms and abbreviations are used throughout. Handling instructions are market with an arrow. XX Always carry out handling instructions in the sequence shown. Bullet points are indicated by a square bullet point at the edge of the line.
Safety EN 2 Safety 2.1 General safety instructions INFO The appliance complies with the stipulated safety requirements. The user is responsible for appliance cleaning and maintenance as well as its safe use. Improper use can lead to personal injury and damage to property. The operating and installation instructions contain important information about installation and operation. These enable you to protect yourself against injuries and prevent damage to the appliance.
Safety Households with children and people with special needs XX The appliance can be used by children aged 8 and above as well as people with reduced physical, sensory or mental capacities or a lack of experience and/or knowledge if they are supervised or have been instructed how to safely use the appliance and understand the resultant risks. XX Supervise children in the vicinity of the appliance. XX Children must not play with the appliance.
Safety EN WARNING! Risk of burns from hot cooktop! The cooktop and its exposed areas get hot during use. Once the cooking zone is switched off, it takes a little while to cool down below 60 °C. Touching hot surfaces can cause serious burns. XX Never touch the cooktop when it is hot. XX Keep children away from the cooktop when it is hot or ensure they are supervised at all times.
Safety 2.3 Safety instructions – installation CAUTION! Lifting heavy loads can cause back injuries! If not correctly handled, removing and installing the device can causes injuries to the limbs or torso. The device must only be installed and assembled by trained specialists who are familiar with and comply with the standard national regulations and supplementary regulations of the local utility companies. XX Removing the cooktop from the packaging is a two-person job.
Safety EN 2.5 Safety instructions – spare parts WARNING! Risk of injury and damage to property! Incorrect components can lead to personal injury or damage to the appliance. Modifications, additions or alterations to the appliance can lead to safety risks. XX Only use original spare parts for repairs. 2.6 Intended use The device cannot be used at altitudes above 2000 m (metres above sea level). The device is designed exclusively for the preparation of food in private households.
Technical data 3 EN Technical data Parameter Value Supply voltage 220 - 240 V Frequency 50/60 Hz Power consumption 3.0 kW Fuse protection, minimum 1 x 16 A Dimensions (width x depth x height) 340 x 515 x 112 mm Weight (incl. accessories/packaging) 9.0 kg Cooktop Power levels 1 - 9, P Wok cooking zone power setting Ø 250 mm Tab. 3.1 2400 W 3000 W Technical data Device dimension 515 281 340 Ø 250 112 Fig. 3.1 Device dimension www.bora.
Device description EN 4 Device description Cooking zone: [1] [4] [5] [6] [7] Observe all safety and warning information during operation (see the Safety chapter). The cooktop has the following features: QQ Automatic heat up function QQ Safety shut-down QQ Electronic power control (9 levels) QQ Child safety lock QQ Pause function QQ power setting QQ Residual heat display QQ Timer functions QQ Pan detector 4.
Device description 4.3.1 Power levels The high power output of induction cooktops results in the very quick heating up of cookware. A slight adjustment is needed in comparison to conventional cooking systems when selecting the power level in order to avoid burning food. Activity Power level Keeping cooked food warm at approx. 75°C v 1-2 Melting of butter and chocolate, keeping food warm Heating up food Fast roasting and roasting of larger amounts Tab. 4.2 P Recommendations for power levels 4.3.
Device description EN Suitable cookware is made of: QQ stainless steel with a magnetisable base QQ enamelled steel QQ cast iron XX Perform a magnet test, if necessary. If a magnet sticks to the base of the utensils, they are normally induction compatible. XX The bottom of the cookware must not have any sharp grooves or sharp edges to avoid scratching the cooktop. XX Place the cookware (without a mat or similar) directly onto the glass ceramic.
Installation 5 Installation 5.3 XX Observe all safety and warning information (see the Safety section). XX Follow the enclosed manufacturer’s information. INFO The device must not be installed above cooling devices, dishwashers, stoves, ovens, washing machines or dryers. INFO The contact surface of the worktops and wall sealing strips must be made of a heat-resistant material (up to approx. 100°C). EN Assembly instructions 5.3.
Installation INFO If the cooktop overheats, performance is reduced or the cooktop switches off completely (see Overheating protection). INFO For sufficient air intake, an opening crosssection in the kitchen units of at least 50 cm2 is recommended. 10 – 40 INFO XX Ensure there is sufficient ventilation underneath the cooktop. INFO Fig. 5.
Installation 10 QQ No 1/0 320 sealing tape is required on the side of the appliance adjacent to the extraction system as the extraction frame can otherwise be damaged. XX With surface mounting, attach the enclosed sealing tape [2] to the underside of the device before installing it. Do not leave any gaps with the exception of the side adjacent to the extraction system.
Installation EN INFO The cooktop [1] lies on the side rail of the cooktop extractor [2], which stabilises it (exception: induction glass ceramic wok). XX Precisely position the cooktop [1]. XX If necessary, use the height adjustment plates to adjust the cooktop’s installation height. 1 XX Check that the cooktop is positioned correctly. XX Once all of the installation work is complete, seal the devices with black, heat-resistant silicone sealant. 5.
Operation 6 Operation 6.1.5 Switching the power setting off early XX Observe all safety and warning information during operation (see the Safety chapter). INFO INFO 6.1 The cooktop may only be operated when the stainless steel grease filter of the cooktop extractor is installed (see operating instructions for cooktop extractor). Clean the cooking zone before using the cooktop for the first time (see the Cleaning chapter). Switching cooktop on/off Switching on XX Press to switch on the cooktop.
Operation EN 6.1.9 Using the timer function You can use 2 timer functions: QQ Short-time timer (egg timer), no automatic switching off of a cooking zone. QQ Automatic cut-off for automatically switching off the cooking zone. You can set a time range of between 1 and 99 minutes for both timer functions. XX If you press first, 1 minute will be pre-set as the starting time. XX If you press first, 30 minutes will be pre-set as the starting time.
Cleaning and Maintenance 7 Cleaning and Maintenance XX Observe all safety and warning information (see the Safety chapter). XX Follow the enclosed manufacturer’s information. XX Make sure that the cooktop and cooktop extractor have been switched off completely and have cooled down prior to the planned cleaning and maintenance work to prevent injury (see the Operation chapter). QQ Regular cleaning ensures the longevity of the product and optimal functioning.
Troubleshooting EN 8 Troubleshooting Observe all safety and warning information (see the Safety chapter). Operating situation Cause Remedy The cooktop cannot be switched on. The fuse or the automatic circuit breaker of the electrical installation of the apartment and/or house is defective. Replace the fuse. The fuse or the automatic circuit breaker trips several times. Call the BORA Service Team. The power supply is disconnected. Have a specialist electrician inspect the power supply.
Decommissioning, d isassembly and disposal 9 Decommissioning, disassembly and disposal XX Observe all safety and warning information (see the Safety section). XX Follow the enclosed manufacturer’s information. 9.1 Decommissioning Decommissioning is understood as final shutdown and disassembly. Following decommissioning, the device can either be installed into other units, sold on privately or disposed of. INFO Electricity and gas connections may only be disconnected by qualified specialists.
Warranty, technical service, spare parts, accessories EN 10 Warranty, technical service, spare parts, accessories XX Observe all safety and warning information (see the Safety section). 10.1 Warranty The warranty period is 2 years. 10.2 Service BORA Service: see back page of operation and installation instructions +800 7890 0987 XX If there are faults which you are not able to resolve yourself, please contact your BORA specialist supplier or the BORA Service Team.
Notes: EN 11 Notes: www.bora.
Notes: EN 26 www.bora.
Nameplate: (please affix) Germany: Australia - New Zealand: BORA Lüftungstechnik GmbH Rosenheimer Str. 33 83064 Raubling Germany T +49 (0) 8035 / 9840-0 F +49 (0) 8035 / 9840-300 info@bora.com www.bora.com BORA APAC Pty Ltd 100 Victoria Road Drummoyne NSW 2047 Australia T +61 2 9719 2350 F +61 2 8076 3514 info@boraapac.com.au www.bora-australia.com.au Austria: BORA Vertriebs GmbH & Co KG Innstraße 1 6342 Niederndorf Austria T +43 (0) 5373 / 62250-0 F +43 (0) 5373 / 62250-90 mail@bora.com www.bora.
