Installation and Operation Guide

EN
22
Gas installation
www.bora.com
6.4.1 Setting up gas taps
1
Fig. 6.4 Set the gas tap
[1] Throttling screw
Perform minimum setting:
Natural gas (NG)
Prerequisites:

Use of G20 nozzles.

It is not necessary to set up the primary air for the gas
burner.
 Ignite the gas burner and set the control knob to the
minimum setting (small flame).
 Remove the control knob by pulling it upwards.
 Use a screw driver to turn the throttling screw [1] to
the right or left in order to adjust the flame correctly.
 Put the control knob back on.
 Ensure that the flame does not go out when changing
between the maximum and minimum setting on the
gas burner.
Liquid gas (LPG)
Prerequisites:

Use of G30/G31 nozzles.

The gas burners do not require the primary air to be set.
 Remove the control knob by pulling it upwards.
 Turn the throttling screw until it stops.
 Put the control knob back on.
 Ensure that the flame does not go out when changing
between the maximum and minimum setting on the
gas burner.
Changing the gas burner nozzle in the gas
burner:
 Remove the pan support.
 Remove the gas burner cover
1
2
Fig. 6.3 Cooktop burner with gas burner nozzle
[1] Gas burner
[2] Gas burner nozzle
 Unscrew the gas burner nozzle [2] from the gas burner
[1]
 Screw the corresponding nozzle for the gas type to be
used into the gas burner [2].
 Position the gas burner cover correctly on the gas
burner [1] so that it lies flat.
 Affix the new labelling for the gas type used (natural
gas/liquid gas) to the nameplate on the underside of
the appliance.
 Install the corresponding gas connection for natural
gas (NG) or liquid gas (LPG). See the Gas connection
section in this chapter.