Installation and Operation Guide

EN
16
Installation
www.bora.com
Attaching the sealing tape
1
2
Fig. 5.7 Sealing tape with ush installation
[1] Black, heat-resistant silicone sealant
[2] Sealing tape
2
1
Fig. 5.8 Sealing tape with surface mounting
[1] Black, heat-resistant silicone sealant
[2] Sealing tape

No sealing tape is required on the side of the appliance
adjacent to the extraction system as the extraction
frame can otherwise be damaged.
 With surface mounting, attach the enclosed sealing
tape [2] to the underside of the device before installing
it. Do not leave any gaps with the exception of the side
adjacent to the extraction system.
 With flush installation, attach the enclosed sealing tape to
the horizontal cutting edge in the worktop cut-out, even if
you seal the device with a silicone sealant [1] or similar.
 Note down the type designation and build number of
the device (FD number) on the back of this manual.
Both details can be found on the nameplate on the
underside of the device.
5.5 Installing the cooktop
INFO Clearance of one millimetre should be planned
between the built-in appliances.
INFO A clearance of two millimetres should be planned
around the built-in appliances.
Surface mounting
x
B ±2
≤ R5
≥ 50
495 ±2
≥ 600
(≥ 50)
Fig. 5.5 Surface mounting
10
10 – 40
Fig. 5.6 Surface mounting cut-out
Cut-out dimensions when installing cooktops or cooktops
and the BORA cooktop extractor next to each other:
Cooktops/cooktop extractor B in mm
1/0 320
2/0 661
3/0 1002
2/1 752
3/2 1184
4/2 1525
Tab. 5.3 Cut-out dimensions