Service manual

TRANSMISSION
2. Remove the gear ring from output shaft.
3. Inspect the shaft and shaft excessive wear or crack.
4. Assemble the output gear and a new snap ring on the shaft.
Shift drum removal and inspection
Spring pressure can cause components to eject suddenly.
Use care during removal. Always wear the appropriate
protective gear
1. Remove shift sensor from drum shaft.
NOTE: Drum shaft components are not serviceable.
Replace Drum shaft as an assembly.
Transmission Reasssembly
NOTE: Lubricate all bearings with clean transmission oil
before assembly.
Clean the gasket surfaces on the crankcase and
transmission cover. Remove all traces of old gasket
material and apply a new base gasket
1. Place the counter shaft into case.
2. Place main shaft washer on bearing housing.
3. Place main shaft into case. Ensure the forward gear toward
inside.
5.7