Service manual

ENGINE
CRANKCASE REASSEMBLY
Crankshaft and Cam/ Oil Chain Installation
Lubricate all bearings with clean engine oil before
assembly.
1. Support the crankcase on blocks.
2. Install the balance shaft. Turn the flat up.
3. Install the PTO end of the crankshaft.
NOTE: Use care not to damage the crankshaft end.
The balance shaft flat must square with crankshaft
PTO end.
3. Install a new gasket onto the right hand crankcase half.
Applying a thin amount of crankcase sealer to the gasket
will help hold it in place.
4. Install 4 flange bolts (circled) from the right side
crankcase.
NOTE: Use care not to damage the crankshaft end.
Crankcase Bolt Torque:
20 Nm(15ft. lbs)
4.29